Home > Suzuki >

Suzuki SV 1000S Bike Specific Kit

Suzuki SV 1000S Bike Specific Kit

Alternative Views:

Our Price: $339.95

Product Code: SUZUKI-SV-1000S

The Original Convertible Handlebar System

Black 46mm Convertible Handlebar Set

Description Technical Specs Download
The Suzuki SV 1000S is a confirmed ConvertiBARS installation.
A confirmed installation means that Convertibars and or a customer, have successfully installed a ConvertiBARS kit on a motorcycle within the range of years listed above and the rise listed below has been achieved, with or without longer lines, while being able to reach the steering stops without permanent damage to the motorcycle. The year range noted above is only an estimate of the years that the motorcycle appears to have had little or no change to the handlebars and fairing, and so the installer should find similar installation issues as noted in the bike specific install notes. A confirmed installation however, does not mean the kit is guaranteed to fit. ConvertiBARS is not liable for any labor times or costs associated with the installation or un-installation of either ConvertiBARS or the stock handlebars. Positioning restrictions between low and high positions do exist. See bike specific install notes for other installation and positioning issues.

*Maximum ConvertiBARS positioning capability.
Measurements are in inches, relative to the stock position, and with Proper Length Lines Position restrictions between low and high positions do exist. Measurements calculated with default handlebar below. See Bottom of page for rise capability with stock lines Fore = Further from the rider, Aft = Closer to the rider.
Vertical Horizontal
Below Above Fore Aft
1 4 1 3

Important Installation Considerations.

Clutch Line - Stock Length - Route behind fork tube.

Hydraulic Brake Line = Stock  4".
All longer lines routed as stock.
Slight fairing contact is ok as long as the 
steering stops can be reached with out damaging the fairing.

Trimming - Depending on handlebar position,
the upper fairing and or windshield may need to be
trimmed for clearance.
Marking the line with tape and using a dremel tool
for trimming is recommended.

*Max Rise allowed with stock lines.
Stock Hydraulic Brake Line 1
Stock Hydraulic Clutch Line 3
Stock Throttle Line 4
Stock Electrical Lines 4

*ConvertiBARS travel relative to the stock location; measurements are in inches.

Share your knowledge of this product. Be the first to write a review »