Home > Kawasaki >

Kawasaki Ninja 1000 (Z1000S) ABS 2011 Bike Specific Kit

Kawasaki Ninja 1000 (Z1000S) ABS 2011  Bike Specific Kit

Alternative Views:

Our Price: $339.95

Product Code: KAWASAKI-NIN-Z1000S-ABS-11

The Original Convertible Handlebar System

Black 50mm Convertible Handlebar Set (With V-ROC Technology) Fits 50mm OD Forks
Silver 50mm Convertible Handlebar Set (With V-ROC Technology) Fits 50mm OD Forks

Description Technical Specs Download
The Kawasaki Ninja 1000 - 2011 ABS is a confirmed ConvertiBARS installation.
A confirmed installation means that ConvertiBARS, and or a customer, have successfully installed a ConvertiBARS Kit on a motorcycle within the range of years listed above and the rise listed below has been achieved, with or without longer lines, while being able to reach the steering stops without permanent damage to the motorcycle. The year range noted above is only an estimate of the years that the motorcycle appears to have had little or no change to the handlebars and fairing, and so the installer should find similar installation issues as noted in the bike specific install notes. A confirmed installation however, does not mean the kit is guaranteed to fit. ConvertiBARS is not liable for any labor times or costs associated with the installation or un-installation of either ConvertiBARS or the stock handlebars. Positioning restrictions between low and high positions may exist. See bike specific install notes for other installation and positioning issues

*Maximum ConvertiBARS positioning capability.
Measurements are in inches, relative to the stock position, and with Proper Length Lines Position restrictions between low and high positions do exist. Measurements calculated with default handlebar below. See Bottom of page for rise capability with stock lines Fore = Further from the rider, Aft = Closer to the rider.
?4 ? 3
Requires Brake Line 6 inches longer than stock.
Customer Added 13 inches to stock ZX10 Clutch Cable. Not sure if this is necessary. Custom lengthening available through Motion Pro.
Important Installation Considerations.

*Max Rise allowed with stock lines.
Stock Hydraulic Brake Line TBD
Stock Hydraulic Clutch Line TBD
Stock Throttle Line TBD
Stock Electrical Lines TBD
The gentleman who provided the fitment details and photos for the Ninja 1000, did not provide us with these numbers. But given the amount of rise shown in the photos and based on our experience, we suspect a longer front brake line is a minimum requirement for any meaningful rise/reach adjustment - perhaps 3 up and 2 back with stock clutch and throttle cables?
*ConvertiBARS travel relative to the stock location; measurements are in inches.

Complete fitment details are a bit sketchy but the photos tell most of the story on the Ninja 1000. Our customer managed a ridiculous amount of rise and reach adjustment but had the work performed by a local shop that was somewhat uncooperative in sharing detailed info with us.
Incentive may be available to another customer willing to provide us with more details! Please call for more information.

Share your knowledge of this product. Be the first to write a review »