Home > Honda >

Honda VFR-800 Interceptor (00-01) Bike Specific Kit

Honda VFR-800 Interceptor (00-01) Bike Specific Kit


 
Alternative Views:


Our Price: $339.95

Price with Selected Options: $339.95

Product Code: HONDA-VFR-800-I-00-01

The Original Convertible Handlebar System

ConvertiBARS*:
Silver 41 mm Convertibars Handlebar system
Black 41mm Convertible Handlebar Set (With V-ROC Technology) Fits 41mm OD Forks
Black 41mm Convertible Handlebar Set(Long Web) (V-ROC Technology)
Bike Specific Completion Pack

Front Brake Line:
Silver/Clear (Alt-2 Dual-two lines) 3 inches Longer Than Stock [Add $98.95]
Black/Black (Alt-2 Dual-two lines) 3 inches Longer Than Stock [Add $109.95]

Clutch Line/Cable*:
Silver/Clear (Hydraulic) 3 inches Longer Than Stock, Teflon lined, Steel Braided [Add $69.95]
Black/Black (Hydraulic ) 3 inches Longer Than Stock, Teflon lined, Steel Braided [Add $76.95]

Additional Completion Products*:
Horn Extension Wire inches [Add $5.95]
Vibration Killers(12oz bar end weights) inches Heavy Bar-ends Kill Vibration [Add $42.50]

Throttle Lines*:
Honda VFR-800 Throttle Lines(00-07) (2 of 2) 2 inches Stock+2 Inches [Add $29.94]
Honda VFR-800 Throttle Lines(98-01) (1 of 2) 2 inches Stock + 2 [Add $29.94]

Qty:  
Description Technical Specs Download
 
The Honda VFR-800(00-01) is a confirmed ConvertiBARS installation.
A confirmed installation means that ConvertiBARS, and or a customer, have successfully installed a ConvertiBARS Kit on a motorcycle within the range of years listed above and the rise listed below has been achieved, with or without longer lines, while being able to reach the steering stops without permanent damage to the motorcycle. The year range noted above is only an estimate of the years that the motorcycle appears to have had little or no change to the handlebars and fairing, and so the installer should find similar installation issues as noted in the bike specific install notes. A confirmed installation however, does not mean the kit is guaranteed to fit. ConvertiBARS is not liable for any labor times or costs associated with the installation or un-installation of either ConvertiBARS or the stock handlebars. Positioning restrictions between low and high positions do exist. See bike specific install notes for other installation and positioning issues.

*Maximum ConvertiBARS positioning capability.
Measurements are in inches, relative to the stock position, and with Proper Length Lines Position restrictions between low and high positions do exist. Measurements calculated with default handlebar below. See Bottom of page for rise capability with stock lines Fore = Further from the rider, Aft = Closer to the rider.
VerticalHorizontal
BelowAboveForeAft
1322

Important Installation Considerations.
Special dual brake line works with linked braking system. Remove the top line(2 lines with a junction block)and the hard cross over line. The replacement lines Both bolt at the master cylinder using a double banjo bolt and 3 washers. On the opposite ends, the line with the male threaded end, attaches to the clutch side crossover block. The second line attaches directly to the right caliper.


*Max Rise allowed with stock lines.
Stock Hydraulic Brake Line 1
Stock Hydraulic Clutch Line 1
Stock Throttle Line 2
Stock Electrical Lines 3

*ConvertiBARS travel relative to the stock location; measurements are in inches.

Share your knowledge of this product. Be the first to write a review »